How do I use the blood pressure device tenso-comfort?


To complete a measuring please proceed as follows:

  1. Push your sleeve up without constricting your arm. The cuff is closed with a velcro closure and should not be too tight or too loose. The device should sit about 1-2 cm away from the heel of your hand.
  2. Switch the device on with the On/Off button. All display elements will appear for about 2 seconds.
  3. The user number blinks on the display, in the measured value memory of which the result of the last blood pressure measurement was stored.
  4. If the user number is not the one assigned to you, press the MEM button until your user number appears.
  5. Confirm the selection of the user number by pressing the On/Off button. This is acknowledged by the measuring device with an acoustical signal. The device now begins by automatically pumping up the cuff.
  6. After reaching the pumped up pressure, the pump switches off and the air slowly escapes from the cuff. The slowly falling cuff pressure is shown on the display now. In addition, as soon as a pulse signal is detected, a heart symbol appears which blinks at the same rate as the pulse.
  7. After the measuring operation is complete, the installed valve opens automatically to quickly let the air out of the cuff. The end of measurement is signalised by a short beep and the measured systolic and diastolic blood pressures, the pulse, and the date and time of the measurement now appear on the display.
  8. Press the On/Off button to switch off the device.

 

Feeling curious? Try it out for free!